Download Print this page

CreatBot DS User Manual page 63

Advertisement

2 Push forward the switch and take it out. 
3 Install the new power switch. 
 
 
 
How to clean the nozzle? 
Sometimes the filament gets stuck at the feeder motor because the pulling speed is not fast enough when 
you unload the filament. Here is the solution: 
1 Heat the nozzle to 260, make the residual 
filament in the nozzle automatically flow out. 
If the nozzle is still blocked, please take it off with 
the wrench when it cools down. 
Caution: Please DO NOT remove the nozzle 
frequently, because it will reduce the lifetime of 
PEEK 
HOW TO 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx