CreatBot DS User Manual page 42

Print from SD Card
1 Input the 3D modelling files in our slicing software and output the
Gcode files in the SD card.
Note: It is better to use the default settings for the first run.
2 Insert the SD card into Printer.
3 Choose "Print from SD card", select the right Gcode.
4 When your 3D print finished, the build plate will move down and be
heated to 50 automatically so as to take out the model more easily.
Use a shovel to take it out gently to avoid the damage of the model.
Note: If the model is difficult to be removed, you can raise the build plate temperature to 60.
Warning: Do not touch the nozzle until it is cooled down totally (The temperature on LCD must be lower than
30 degrees)