Download Print this page

CreatBot DS User Manual page 14

Advertisement

3).Take out the nuts and screwdriver from the 
tool box to fix the platform and platform holder 
firmly. 
Note: After installing the platform installation, 
please tighten the four black screws a little bit 
more under the build plate to lower it to avoid 
knocking the extruders in next operation. 
4).Connect the power wire and data cable of 
platform with the connectors. 
Caution: Make sure the plugs are fully connected. 
Otherwise the platform may not heat or may over 
heat. 
 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx