option is at your own risk. Type‐A is depended on the model normals and tries to keep some internal holes in
tacked. Type‐B ignores all internal holes and only keeps the outside shape per layer.
Keep open faces: This expert option keeps all the open bits of the model intact. Normally CreatBot tries to
stitch up small holes and remove everything with big holes, but this option keeps bits that are not properly
part of anything and just goes with whatever it is enable you to slice models otherwise failing to produce
proper paths. As with all "Fix horrible" options, results may vary and use at your own risk.
Extensive stitching: Extensive stitching tries to fix up open holes in the model by closing the hole with
touching polygons. This algorithm is quite expensive and cloud introduce a lot of processing time. As with all
"Fix horrible" options, results may vary and use at your own risk.
Plugins
There are 3 plugins installed, more are
available to download. These 3 plugins will
help to give stronger control feature. You can
set different parameter with different print
heights to have more accurate model.
Double‐click certain plugin name to start
using. After starting using you can set
parameter in below setting interface.
If you want to cancel this plugin, click "X" on
the right top of parameter setting interface.
Change Filament At Z: You can change the
filament in the printing process at a certain
height of the print.
Pause at height: You can pause printing at a
certain height of the print, and you can
precisely locate the print head position.
Tweak At Z: You can reset the printing
parameters at a certain height of the print,
this is a powerful option for experts.
You can reset printing speed, flow, bed
temperature, nozzle temperature and fan
speed.
Need help?
Do you have a question about the CreatBot DS and is the answer not in the manual?