Download Print this page

CreatBot DS User Manual page 23

Advertisement

Esteps/mm: Transmission ratio of feeding motor 
2.3 ‐ Restore Failsafe: Please do NOT change any data setting here in this menu. 
2.4 ‐ Save memory: Record the coordinate of printing stop 
2.5 ‐ Restore factory: Restore the manufacturer default settings 
2.6 ‐ Firmware version: Current firmware version 
Menus in Printing Process 
During the printing, you can press the knob to change some printing settings. 
1. Tune: Re‐set some parameters 
‐ F/R: the actual printing speed takes the percentage of the pre‐set speed in the software. It can be 
adjusted while printing according to the actual situation. 
‐ Nozzle: Temperature setup of left nozzle 
‐ Nozzle 2: Temperature setup of right nozzle 
‐ Bed: Temperature setup of build plate 
‐ Fan speed: Fan speed setup 
‐ Flow: Filament feeding flow rate  
‐ Flow 0: Filament feeding flow rate of left nozzle 
‐ Flow 1: Filament feeding flow rate of right nozzle 
‐ Auto Temp: Set all the above temperature automatically 
‐ Change filament: To stop the printing and change the filament. It will record the printing stop position so 
as to continue to print after filament changing. 
2. Control: Please do NOT change any data in this menu if without specialist experience. 
3. Pause: To stop the printing, but it will record the printing stop position to continue the printing. 
4. Stop Print: To finish the printing job 
 
 
 
 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx