Download Print this page

CreatBot DS User Manual page 52

Advertisement

Q: Model surface is unsmooth 
 
A: Reduce the retraction travel; Or reduce minimal extrusion before retracting; 
Note: Please reduce the retraction amount if retracting frequently. 
Q: Model is easy to fall off 
A: Having not used the Kapton tape or the Kapton tape loses stickiness; Or the model bottom is too small, 
you can use a hot melting glue gun to help; Adding support structure to support model; Using the feature in 
Software of Advance‐Quality‐Cut off object bottom. 
Q: There is the joint dislocation between the parts while dual colour printing. 
A: Q: There is the joint dislocation between the parts while dual colour printing. 
Q: Hard to remove the support structure 
A: Turn the direction of model properly in Software; The support density should not be set too high; Divide 
the model into different parts to print if necessary. 
Q: Failed prototyping of small model 
A: If printing a small model, the extruder will always move in a small space, so the heat will be concentrated 
in the model, and hard to be distributed. 
That's why it is hard to print the very small model. 
The solution is to print 3‐4 pieces of the small model together. If so, the extruder will move among different 
models, leaving time for heat dissipation. 
Q: CreatBot 3D Printer stops suddenly sometimes 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx