Download Print this page

CreatBot DS User Manual page 44

Advertisement

Maintenance 
Build Plate 
Ensure that the plate is clean. Bubbles, scratches, dust, and oil from your hands are avoided. 
1. Use tweezer to remove filament residue. 
2. Do not touch the platform glass with sharp things. 
3. If do not use the printer for a long time, please clean up the tape, clean the glass and fully release the four 
black screws under the build plate. 
Cleaning the filament feeder 
After a lot of printing, the wheel in the filament feeder might accumulate small plastic particles. 
You can clean this with a simple brush. 
1 Remove the black screw on the feeder motor 
totally. 
Note: De burr the aluminium casting at the entry 
and exit holes of which the filament goes through 
to ensure that filament is not scraping on any 
burrs which will also accumulate plastic. 
2 Select "Prepare"> "move axis" > "move 1mm"> 
"move extruder ". The feeder gear will start to 
work. 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx