Download Print this page

CreatBot DS User Manual page 41

Advertisement

Feed the Filament 
1 Preheat the nozzle: 
Choose "Prepare">"preheat PLA ( or ABS)" on LCD. Choose the nozzle 
you want to preheat. 
2 Feed the end of the spooled filament into the filament guide tube, 
where it attaches to the extruder. 
3 Continue to feed the filament in until it emerges from the nozzle. 
Note: Please DO push the filament GENTLY 
If filament attaches the nozzle, just keep them attached, stop pushing 
hardly. Otherwise, the nozzle connection could be broken. 
After the nozzle is preheated enough, the filament will flow out from 
nozzle naturally. 
4 Tighten the black screw to fix the filament with the clamp, not too 
loose or too tight. 
Caution: 
1. Ensure the clamp is not too tight or too loose, otherwise, filament feeding will have problem causing 
failure prints.  
 
2. After feeding successfully, check if filament has twining and knotting to ensure filament feeding smoothly.
 
3. Lubricate the XY axis and sliding blocks to avoid motion stuck. 
 
 
 
 
 
 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx