Download Print this page

CreatBot DS User Manual page 39

Advertisement

7 When appear some big bubbles, just use 
needle(21) stick into them. Then smooth them 
with yellow board. 
8 After sticking the tape on the plate, please 
uncover the other side of the tape. 
Note: After several printing, the stickiness is not 
strong enough, please change the tape. 
 
 
 
Levelling Build Plate 
Notice: 
• Tightening the black screw (turning them to the right) to reduce plate height.  
• Loosening the black screw (turning them to the left) to increase platform height. 
• The gap between the nozzle and the build plate should be about 75% of the layer thickness you set in the 
software. 
Why Levelling Build Plate is Important? 
Frequent build plate levelling can keep CreatBot 3D Printer best performance. Re‐levelling cannot hurt the 
printer but without levelling will decrease your success rate of printing. 
• If the build plate is too far from the extruder nozzle, or if one part of the build plate is farther from the 
nozzle than another part, your object might not stick to the build plate. 
• If the build plate is too close to the extruder nozzle, the build plate will block the extruding of filament from 
the nozzle. The nozzle will scratch the build plate. 
• Frequent build plate levelling will help to ensure that objects always stick well to the hot bed. 
Plate Levelling Guide 
1 Tightening the four black screws as tight as it can to reduce the build 
plate height to avoid collision between nozzle and plate. 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx