Stick the Kapton tape
Stick the kapton tape to the build plate.
It is the high temperature resistance double sided
tape, it contains three layers.
1 Clean the plate carefully to ensure the clean
and tidy, it will help you avoid bubbles after
applying the tape on it.
Take the tape out. If covering the plate
completely, it will need 3 lines of the tape.
2 Uncover one side of the tape, and then try to
stick it on the plate. Please ensure the tape is
smooth enough without any bubbles.
3 You can use the yellow board in tool box to
push and press it while sticking.
4 Cut the tape off at the same width of the plate.
5 Stick the second line in the same way.
6 Cut off the parts on the screws when sticking
the third line.
Need help?
Do you have a question about the CreatBot DS and is the answer not in the manual?