CreatBot DS User Manual page 29

≤70mm/s. ≥70mm may cause the step motor loosing steps, which will reduce the model printing accuracy.
Printing Temperature: Main extruder temperature (default as left extruder), setting according to the
different melting temperatures of different filaments.
2nd extruder temperature: Vice extruder temperature (default as right extruder), setting according to the
different melting temperatures of different filaments.
Default main extruder: Choose which one to be the main extruder. Default as left extruder. After finishing a
model and you want to print another model in different filament(different colours and different materials).
Changing vice extruder as main extruder can solve frequent changing filament problem. This function can
come effective only when printing single colour filament.
Bed temperature: Setting according to the different melting temperatures of different filaments.
Close bed after layer: Close bed temperature after certain layers. Not only energy, but also can prolong the
life of the hot bed. 0 disable this feature.
Support
Support type: For the model has parts hanging in the air, support structure is a must when printing to ensure
the parts hanging in the air will not collapse.
‐None: No support, if you print model with parts hanging in the air but choose structure as none, the parts
hanging in the air may droop.
‐Touching Build Plate: Most commonly used support type, means the support will only been created when
the support structure touches the build plate.
‐Everywhere: Create support wherever there is part hanging in the air.
Note: Support structure may affect the smoothness of model surface and printing speed. If not essential,
recommend to modify or split model to reduce the use of support.
Platform adhesion type: Different options that help in preventing corners from lifting due to warping.
‐ None: Default form of using outsider lining.
‐ Brim: Adds a single layer thick flat area around your object which is easy to cut off afterwards, and the
recommended option.
‐ Raft: Adds a thick raster at below the object and a thin interface between this and your object.
Note: Enabling the brim or raft disables the skirt.
Support dual extrusion: Which extruder to use for support material. For easy break‐away support you can
use either extruder.
You can choose main extruder (left extruder) to print main structure, 2nd extruder (right extruder) to print
soluble support material.