Download Print this page

CreatBot DS User Manual page 61

Advertisement

8 Reinstall all the parts in order. 
Notice: Before reinstalling all the parts, wining 
one layer PTFE thread seal tape on the screw 
thread of the nozzle, then screwing the nozzle 
into the hot end. Otherwise, there may be the 
filament leakage problem. 
 
 
 
 
How to tight the belt? 
1 Shore up the belt by inserting a small iron bars ( 
diameter about 2 mm). 
2 Loosen the two screws a little ( not unloading ), 
the belt will be loose. 
HOW TO 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx