Download Print this page

CreatBot DS User Manual page 50

Advertisement

TROUBLESHOOTING 
Printing Problems 
Q: Problem with first layer printing 
Q: The filament doesn't stick onto the build plate. 
‐ A1: The gap between nozzle and build plate is too big. 
‐ A2:The build plate has not been levelled yet. 
‐ A3: Kapton tape has not been sticked on the build plate yet; or the non‐sticky top layer of the Kapton tape 
is not removed. 
‐ A4: The first layer's height is too small, recommended setting as ≥0.2 
Q: Little filament stick onto the build plate. 
A: The gap between nozzle and build plate too small which may cause the nozzle clogged. 
Q: No filament output from the nozzle. 
A: The filament has not entered into the end of the nozzle yet when you feed the filament. 
Q: The edge is lifted, or the print cracked while printing with ABS filament 
Please keep the build plate heated continuously; Change a new Kapton tape; Slow down the printing speed 
of first layer; Use the enclosure plate to keep the constant temperature while printing; Avoid air condition's 
blowing directly; Inside ventilation should not be so strong. 
Q: Model surface is loose with crack 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx