Download Print this page

CreatBot DS User Manual page 12

Advertisement

Setting Up Your CreatBot 3D Printer 
A‐ Install the Handles 
1). Locate the four holes are on the top of the 
printer. These are used to mount the handles. 
2).You will need a screwdriver, four screws and 
two the two handles. 
3).Use the screwdriver to fix the two holders on 
left and right of the printer top side. 
Note: Please ensure that you have tightened the 
nut sufficiently. Use a spanner to hold the nut in 
place when tightening. 
4).Handle installation complete. 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx