Download Print this page

CreatBot DS User Manual page 34

Advertisement

Skirt 
Line count: The skirt is a line drawn around the object at the first layer. This helps to prime your extruder, 
and to see if the object fits on your platform. Recommended setting as 1 with best  
performance. Setting this to 0 will disable the skirt. Multiple skirt lines can help priming your extruder better 
for smaller objects. 
Start distance: The distance between skirt line and model. Default distance is 3. 
Minimal length: The minimal length of the skirt, if this minimal length is not reached it will add more skirt 
lines to reach this minimal length. Recommended setting as 250 with best performance. If the line count is 
set to 0 this is ignored. If the model is too small to have a too short skirt line will not help to clean nozzle. 
Infill 
Solid infill top: Create a solid top surface, if set to false the top is filled with the fill percentage. Disable this 
feature and set fill density as 0 to print cups/vases that are without top model. 
Solid infill bottom: Create a solid bottom surface, if set to false the bottom is filled with the fill percentage. 
Disable this feature and set fill density as 0 to print buildings that are without bottom model. 
Infill overlap: Amount of overlap between the infill and the walls. There is a slight overlap with the walls and 
the infill so the walls connect firmly to the infill. Recommended setting as 10 with best performance. Too big 
will influence quality of model surface. 
Support 
Fill amount: Support print density. 
Recommended setting as 15 with best performance. More density makes the support not easy to remove. 
Less density influences print quality. 
Distance X/Y: Distance of the support material from the print, in the X/Y directions. 0.7mm gives a nice 
distance from the print so the support does not stick to the print. Too far will influence support performance.
Distance Z: Distance from the top/bottom of the support to the print. A small gap here makes it easier to 
remove the support but makes the print a bit uglier. 0.15mm gives a good separation of the support material. 
Too far will influence support performance. 
Birm 
Birm line amount: Default as 5, more lines, more firmly the model sticking to platform. 
Raft 
Extra margin: If the raft is enabled, this is the extra raft area around the object which is also rafted. 
Line spacing: When you are using the raft, this is the distance between the center lines of the raft line. 
Fix Horrible 
Combing everything ( Type‐A )/( Type‐B ):This expert option adds all parts of the model together. The result is 
usually that internal cavities disappear. Depending on the model this can be intended or not. Enabling this 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CreatBot DS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Creatbot dmCreatbot dhCreatbot dx