Welding Task Selection; Accessory Components For Operating Point Setting - EWM Taurus 355 Basic TDM Operating Instructions Manual

5.11.2 Welding task selection

Selection of a welding task involves the interaction of the controls on the welding
machine and the wire feed unit. After the basic settings are made on the welding
machine, the operating point and other parameters can be set on the wire feed unit.

5.11.2.1 Accessory components for operating point setting

The operating point setting can also be made with the accessory components
•
R11 / RG11 remote control
•
Up/Down torch with two rockers (2 U/D)
You will find an overview of accessory components in the "Accessories" chapter. See the operating
instructions for the machine in question for a more detailed description of the individual machines and
their functions.
099-005221-EW501
16.04.2014
NOTE
1
30
25 35
40
20
15 45
10 50
4
Figure 5-14
Design and function
2
8 9 10
6 7
11
5 12
4 13
3,5 14
3 15 3
2,5 16
2 18
1,5 20
1 22
0,5 24
m /m in
MIG/MAG welding
37