Notes On The Installation Of Welding Current Leads - EWM Taurus 355 Basic TDM Operating Instructions Manual

5.4

Notes on the installation of welding current leads

Incorrectly installed welding current leads can cause faults in the arc (flickering).
Lay the workpiece lead and hose package of power sources without HF igniter
(MIG/MAG) for as long and as close as possible in parallel.
Lay the workpiece lead and hose package of power sources with HF igniter (TIG) for as
long as possible in parallel with a distance of 20 cm to avoid HF sparkover.
Always keep a distance of at least 20 cm to leads of other power sources to avoid
interferences.
099-005221-EW501
16.04.2014
Design and function
Notes on the installation of welding current leads
NOTE
Figure 5-2
25