Table of Contents
Advertisement
Positioning the projector
Warning! Failure to comply with the following could result in death or serious injury.
• Two people are required to safely lift and install the projector.
Place the projector on a sturdy, level surface and position it so that it is perpendicular to the screen
at a suitable distance. The further back the projector is positioned for the screen, the larger the
image will be.
To level the projector adjust its three feet. With the projector positioned perpendicular to the screen
the image will appear rectangular instead of keystoned.
Connecting a source
The input panel where all source connections are made, is located at the back of the projector. Each
input is clearly labeled for easy identification. Depending on the type of option card installed,
connect your source using the appropriate cable(s), as follows:
Option card
Analog Input Card
Dual 3G/HD/SD-SDI input card
Dual Link DVI input card
Twin DHDMI input card
Video Decoder input card
DMX512 interface card
TwinDisplay input card
M Series Quick Start Guide
020-101941-01 Rev. 1 (07-2015)
Connection
Connect three-, four-, or five-wire RGB source to Red/Pr, Green/Y, Blue/Pb, H/C
and V using three, four or five BNC connectors as required.
Connect the SDI (Serial Digital Interface) cable to one of the two inputs, 1-IN or
2-IN. Both standard-definition (SD) and high-definition (HD) signals are
accepted and automatically recognized on either input.
Connect a single or dual DVI video signal to the DVI-I connector, an analog
video signal to the DVI-I connector, or an analog video signal to the VGA
connector. The DVI signal may contain HDCP (High-Bandwidth Digital Content
Protection).
Connect HDMI (High-Definition Multimedia Interface) cable to one of the two
inputs, 1-IN or 2-IN.
Depending on the source you can apply the following;
• Composite video source to 1-CVBS, using a BNC Cable — the same signal can
be used on 4, 5, or 6 when input is selected as CVBS.
• A component signal on Inputs 4(Pr), 5(Y), 6(Pb) using BNC Connectors —
grouped as a component input, YPbPr,
• S-Video to one of the two, 2-SVID or three-SVID using S-Video cable.
• S-Video using two BNC cables, with Luma (Y) connected to 4 (Sy) and
Chroma (C) connected to 6 (Sc) — must be grouped as one S-Video + one
CVBS.
Has two 5pin XLR connectors - one (input) male and one (output) female. If
there is active communications on the DMX512 Interface card the power LED
will blink between low intensity and high intensity.
Accepts DisplayPort 1.1a inputs from one or two DisplayPort sources.
Installation and Setup
11
Advertisement
Table of Contents
