Christie HD14K-M2 Quick Start Manual page 10

3. Fully insert the assembly straight into the lens mount opening without turning and press with
your hand as shown.
4. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the
lens assembly in place.
5. Remove the front lens cap.
6. For added stability such as motion application, fasten the security screws provide with the lens-
mount.
7. Use a 5mm hex driver to fasten the red security screws provided with the lens mount, or hand
tighten the lens retaining screws attached to the lens. This is recommended for heaviest lenses
such as 0.73:1 and 1.2:1.
8. If the projector is hoisted or installed in an overhead position use the lens red security screws
or the lens retaining screws.
M Series Quick Start Guide
020-101941-01 Rev. 1 (07-2015)
Installation and Setup
10