Table of Contents
Advertisement
6. Use a 6 mm Allen key to tighten the six M8 bolts securing the base plate to the bottom of the
projector.
7. When flying projectors overhead use the M8 safety point.
Stacking multiple projectors
The projectors can be stacked and hoisted in either an upright or inverted positions. Remove the
locking pin from each stacking leg prior to alignment and ensure the four stacking legs are fully seated
on the lower stacking frame.
1. With one person positioned on each side of the stacking
frame, lift the top stacking frame onto the bottom stacking
frame, aligning all four stacking legs between the frames.
Warning! Failure to comply with the following could
result in death or serious injury.
• Failure to engage the locking pin may cause the
2. Insert the locking pin through the holes in the stacking legs.
Make sure each pin is fully inserted.
M Series Quick Start Guide
020-101941-01 Rev. 1 (07-2015)
projectors to separate.
Installation and Setup
14
Advertisement
Table of Contents
