Factory Reset - Extron electronics XTP SR HDMI User Manual

Screen Saver panel
The panel on the
Screen Saver
saver. When enabled, the output sync is disabled after a specified amount of time.
5 Never — Click the
Never
button to disable the screen saver
setting.
6 Duration — Enter a value in the
field, or click the
After:
arrows to specify a duration
Down
of inactivity before a screen saver is
activated. The duration is set in minutes.
HDCP Mode panel
The panel on the
HDCP Mode
signal.
7
Follow — Click the
Follow
button to set the HDCP encryption
of the output signal to follow the
input signal setting.
8 Always Encrypt Output — Click
the
Always Encrypt Output
button to always encrypt the output
regardless of the encryption status of the input signal.
Switch Mute panel
The panel on the
Switch Mute
switching.
9 Basic mute — Select the
check box in the
Basic Mute
to mute the output during switching.
If enabled, enter a value in the
associated
Duration:
the and arrows to specify
Up Down
a mute duration between switching.
The duration is set in 0.5 second increments.
- Advanced mute — Select the
check box in the
Enable
panel to add an additional
Mute
mute to help compensate for
switching between different input
resolutions.
If enabled, enter a value in the
associated
Duration:
the and arrows to specify a duration of the additional mute. The duration is set
Up Down
in 0.5 second increments.

Factory Reset

Click the button (see figure 32,
Factory Reset
(except for firmware).
NOTE: This is the same as the
command on page 28).
XTP SR HDMI Scaling Receiver • XTP System Configuration Software
screen is used to enable or disable a screen
General
radio
and
Up
screen is used to set HDCP encryption of the output
General
radio
radio
screen is used to enable or disable mutes during
General
Enable
panel
field, or click
Advanced
field, or click
) to reset the receiver to factory settings
=
E
SIS command (see the
ZXXX
Factory defaults SIS
41