Issuing Controls To A Centrally Located Ir Device - AMX endeleo UDM 1604 User Manual

(2)
(3)
3.2

Issuing controls to a centrally located IR device

(1)
Figure 3-2: The Command bar for issuing commands to a Device
(2)
3-2
UDM1604-USG – 2.0 - 0606
Device Configuration & Control
Name the Device accordingly e.g. DVD Rack2.
Note!
Ensure the correct port is selected. Device 1 refers to
IR TX1 at the rear of the UDM Hub, Device 4 refers to
IR TX4 at the rear of the UDM hub.
Configure the Device with the relevant IR protocol if
appropriate. Refer to the Protocols and IR Learning
section of this manual on creating or learning IR
protocols.
Note!
The UDM hub will have to learn the device's IR
protocol ie which button on its remote performs
which function. Refer to the Protocols and IR
Learning section of this manual on creating or
learning IR protocols.
The control bar at the bottom of the browser screen
enables specific controls to be executed via the browser
connection.
Select the control(s) to be performed for this device.
Two controls can be issued to a device 1
Figure 3-3: Optional controls for a device
Note!
The first command is limited to Power On, Off and
A/V Select.
Section 3
st nd
and 2 .