Copying The Hub Configuration File; Copying Protocols Between Endeleo Rx Units - AMX endeleo UDM 1604 User Manual

Section 7
Advanced Administration
7.3

Copying the Hub Configuration file

Copying the Hub Configuration file permits the Administrator to backup
key data entered by Administrators such as Input names, Port names,
Devices and the Hub setup.
To backup the Hub Configuration file;
7.4

Copying protocols between Endeleo RX units

(5) Upload the file to any other ports requiring this
upgrade by changing the last 3 digits of the
command to the relevant port number. For example
tftp –i 192.168.0.96 PUT R26201610800.002 to
upload the file to port 2 on the UDM hub with IP
address 192.168.0.96.
(6) The command window can be closed.
Note;
Ensure the tftp client has been installed on the PC
which will be used to send files to the hub. Install tftp
client if necessary, consult with Endeleo support as to
the appropriate client.
(1) Run the tftp client.
(2) Start a command session on the PC. Change to the
directory where the Hub Configuration file is to be
stored on the PC eg cd\hub.
(3) Type in the following command at the prompt
observing the parameters below;
tftp –i get [IP address] hxxxxx.hub
Where hxxxxxx.hub is the name of the hub
configuration file. If the name of the Hub
Configuration file is not known typing in h followed
by xxx will find the file, as there is only one file
beginning with h in the UDM Hub.
Note;
Once protocols have been learned by the Hub through
the Web Browser, they will remain on the Hub. Endeleo
recommends the Web Browser be used at all times to
allocate protocols to Receive units.
UDM1604-USG – 2.0 - 0606 7-3