Configuring Serial Control Via The Endeleo Bowser Interface - AMX endeleo UDM 1604 User Manual

RJ11
Pin 1
Pin 2
Pin 3
Pin 6
Pin 4 and 5
Pin 1
Not used
Not used
Not used
7.10.2 Configuring Serial Control via the Endeleo Bowser
Interface
Device serial codes can be configured from the Status page.
The Receive Unit can currently store up to a maximum of 8 serial
commands per device depending on the length of the serial string.
7-16
UDM1604-USG – 2.0 - 0606
Advanced Administration
Figure 7-15: RJ11 Connector
Name
DCD
TD
RD
DSR
SGND
DTR
RCS
RTS
RI
Note;
The serial device controls are stored in the Endeleo
Receive Unit and care should be taken to keep any
serially programmed units associated with the correct
screen type.
(1) Ensure the Status option has been selected.
(2) Click on the Port name hyperlink to display the port
configuration page. From here serial codes can be
entered according to the device type, make and
model etc.
Section 7
Description
Data Carrier Detect
Transmit Data
Receive Data
Data Set Ready
Ground
Data Terminal Ready
Clear To Send
Request To Send
Ring Indicator