Updating The Endeleo Rx Unit With The Serial Protocol - AMX endeleo UDM 1604 User Manual

(6)
(7)
(8)
(9)
4.2

Updating the Endeleo RX unit with the Serial protocol

(1)
(2)
(3)
(4)
(5)
4-2
UDM1604-USG – 2.0 - 0606
Protocols and IR Learning
Key in the serial string (Serial command) equivalent
for this action.
Note;
The serial string which reflects the action has to be
accurate for the serial command to work. Consult the
Manufacturer's web site or documentation to ascertain
the correct string for this serial device.
Click on Add to create the new protocol.
Repeat if necessary for other serial commands which
are to be stored under this protocol name.
Once completed the protocol can now be assigned to
relevant devices.
Note;
It is presumed that the serial device connected to the
Endeleo RX has the appropriate serial settings as
described and the correct serial cable/pinouts
configured in order to function correctly with the
Endeleo RX unit.
Warning!
An Endeleo receive unit, which will issue the relevant
serial commands to the device, must be connected to
the relevant port via a Cat5/e/6 cable. Remember the
serial commands are stored within the Endeleo RX unit.
Ensure the Serial Protocol and commands have been
created previously.
Click on the Status page.
Click on the port number hyperlink which the serial
device is attached to. (It is the Endeleo RX unit which
will issue the serial command over the serial cable
connected between the RX unit and the device).
Once the port properties become visible click on the
arrow to the right of the Protocol field.
Select the Serial protocol which this RX unit will
download. This may take a few minutes depending on
how many commands are within the protocol.
Section 4