Resetting Video Compensation Settings; Cascading Hubs; Configuring A Master Hub - AMX endeleo UDM 1604 User Manual

7.7.2

Resetting Video compensation settings

The x command resets all compensation settings at the RX back to
default.
7.8

Cascading Hubs

UDM Hubs can be connected (cascaded) together to increase the
number of inputs which can be delivered to the end points. This is
known as cascading hubs together.
The Cascade In port and Cascade Out ports will be used when cascading
2 Hubs together.
A cascade cable UDM-EXP-01 will be required to connect Hubs together.
This cable can be purchased from Endeleo, as it is not shipped with
the Hub.
7.8.1

Configuring a Master Hub

A Master Hub will have to be configured (to synchronise audio) in any
cascaded system. This will normally be the first Hub in the system and
should follow a top (Master) to bottom (Slave) configuration. In theory
there is no limit to the amount of Hubs cascaded i.e. one Master only
but multiple Slaves.
To configure a hub as a Master Hub;
7-8
UDM1604-USG – 2.0 - 0606
Advanced Administration
(1) Use Hyperterminal to connect to the RX via its serial
port.
(2) At the command prompt type in setup. Once in
setup mode type in x to reset the compensation
settings if required.
(1) Click on the Setup option.
(2) Click on the Cascade master option to configure the
Hub as a Master Hub.
Figure 7-7: Enabling a Master Hub
Section 7