Restoring Factory Settings - NCR 7454 Hardware User's Manual

Chapter 3: Setup 3-3
Note: If you are not using an external keyboard, you can touch the
menu controls at the bottom of the screen. If you encounter difficulty
doing this, recalibrate the screen.

Restoring Factory Settings

To automatically reset all values to their default settings for the current
screen, press F9. The terminal will automatically load BIOS default
CMOS values for boot up.
To reset all BIOS settings to their default settings go to the Exit menu,
press F9, select either Save Changes & Exit or Save Changes, and press
Enter.
Refer to the BIOS Default CMOS Values section later in this chapter for
the pre‐installed Setup defaults.