NCR 7454 Hardware User's Manual page 114

4-4 Chapter 4: Operating System Recovery
13. Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD‐ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
14. Follow the DOS screen prompts. After each entry you are asked to
confirm your input. You can use 1 or y for Yes, 2 or n for No.
15. Enter whether or not you want to perform
(Answering Yes takes twice as long, but is recommended.)
If Yes is selected:
•
The Ghost
®
FAT clusters.
•
The Ghost error file (GHOST.ERR) is displayed before
rebooting
If No is selected:
•
The Ghost error file is displayed before rebooting only if Ghost
aborts.
Caution: If the error file is displayed, the batch file pauses for
user input before rebooting. You may use Ctrl‐C to cancel out of
the batch file if you want to see the error file again, but nothing
should be done that writes to the hard disk before rebooting.
GHOST.ERR is on the RAM disk and is lost on reboot.
software verifies write operations and handles bad
.
Disk verification