Wireless Lan Communications - NCR 7454 Hardware User's Manual

Chapter 1: Product Overview 1-11
When the platform is in the Soft OFF state (refer to Advanced Power
Management section that follows), receipt of a Wakeup Packet on the
LAN can return the system to the ON state, if this feature is enabled by
software.
Note: Due to limitations of the LAN controller and the OS, all features
described in the Network Device Class specification may not be
available.
100Base‐T is wired identically to 10Base‐T, except that the twisted pair
cable must be Category 5 and the hubs must permit 100 or 10/100 Mbps
operation. Although 10Base‐T will operate on Category 3 twisted pair,
or NCR "747" cable, an upgrade to Category 5 is required for 100Base‐
T.
A customer desiring to use the terminal in an existing 10Base‐T
environment can do so and simply run at 10 MB. In order to upgrade to
100Mbps, Category 5 cable and 100 or 10/100 hubs must be installed.
NCR strongly recommends the use of Category 5 for all new cabling,
even if the customer initially intends to run only 10Base‐T.
LED Indicators for Link Integrity (verifies cable and hub connection are
good) and LAN speed is provided on the Processor Board near the row
of connectors at the bottom of the e‐box. The LED is ON (yellow) when
the speed is running at 100 Mbps.
Link Integrity is provided to the PC chipset to permit boot‐up software
to verify the presence of the LAN connection. Software must provide 2
seconds after power‐up in order for the Link Integrity signal to become
valid.

Wireless LAN Communications

Where a wired Ethernet connection is not desired a wireless LAN
adapter may be installed in the PCMCIA socket. This requires that the
PCMCIA daughter‐card feature be installed. A wireless LAN used in
the terminal must meet the following requirements: