2-18 Chapter 2: Hardware Installation
Installation Procedure
1. Route the cable (display connector end) up through the Power
Supply Cover, Display Post, and Top Bracket. This is a tight fit and
the connector has to be angled in order to make it though the
openings. Use care to not damage the wires.
Top Bracket
Display Post
Power Supply Cover
2. Insert the post into the hole on the top of the Power Supply Cover.
Note the orientation above. The slot on the bottom end of the post
should face the inside of the cover.
3. Install the Top Bracket onto the post.
4 x 20 Integrated
High-Post Cable
19949a