2-6
Chapter 2: Hardware Installation
Installing Peripherals
Installing a Transaction Printer
This section describes how to install transaction printers and other
peripherals on the 7454 terminal.
Transaction printers can connect through a non‐powered RS‐232 or
USB connector as defined in the table below. Each printer except the
2214 requires an external power supply. The illustrations show how to
connect to the 7194 printer. Connecting to the other printers is done in
the same manner. Refer to the corresponding printer owner's manual
for illustrations of the connector locations.
Printer Type
2214 Thermal Fiscal
7158 Thermal Receipt/Impact Slip
7166 Thermal Receipt/Impact Slip
7167 Thermal Receipt/Impact Slip
7194 Thermal Receipt
7196 Thermal Receipt
7197 Thermal Receipt
Owner's Manuals/Guides
•
NCR 7158 Thermal Receipt/Impact Printer Owner's Guide
(B005‐0000‐1112)
•
NCR 7166 Multifunction Printer Setup & User's Guide
(B005‐0000‐1002)
•
NCR RealPOS 7167 Two‐Station POS Printer Owner's Manual
(B005‐0000‐1406)
•
NCR 7194 Thermal Receipt Printer Owner's Guide (B005‐0000‐1097)
•
NCR 7196 Thermal Receipt Printer Operator Manual (B005‐0000‐1171)
•
NCR RealPOS 7197 Receipt Printer Owner's Manual (B005‐0000‐1409)
RS-232
USB
√
√
√
√
√
√
√
√
√
√
√