Completing The Os Installation (Win95); Completing The Os Installation (Dos) - NCR 7454 Hardware User's Manual

4-8 Chapter 4: Operating System Recovery

Completing the OS Installation (Win95)

The system automatically reboots when the image recovery is complete
and starts the software installation. This installation also installs most
of the additional software and drivers that are included in the disk
image. Complete the installation as follows.
1. After the terminal reboots, press Next at the Windows Setup screen.
2. At the User Information screen, enter the User information. This
can be done using a keyboard or you can use the touch screen
keyboard. After entering the information, press
3. Open the Control Panel and run the MicroTouch screen calibration.

Completing the OS Installation (DOS)

The system automatically reboots when the image recovery is complete
and opens at the DOS C: prompt.
or touch .
Enter OK