NCR 7454 Hardware User's Manual page 24

1-12 Chapter 1: Product Overview
•
Integrated antenna that meets the requirements of PCMCIA (PC
Card) Extended Type 2 card definition (a maximum of 5‐cm
additional length).
•
Power consumption within the capabilities of the PCMCIA
daughter‐card.
•
Signaling requirements within the capabilities of the terminal
PCMCIA interface. The main restriction is that DMA transactions
are not supported over the PCMCIA interface.
•
Device drivers for the targeted operating system must exist.
•
Appropriate infrastructure (server support, Base Stations, Ceiling
Antennas, etc) must be present in the installation site, and the
maximum RF range of the wireless system must not be exceeded.
Interoperability ‐ While the 802.11 standard provides an interoperable
protocol definition, there are vendor‐specific extensions to the protocol
that encourage users to stay with one supplier's equipment. This also
applies to wireless infrastructure and access points, 802.11 does not
govern this operation. Mixing of RF suppliers on a site is not
recommended until the RF suppliers have demonstrated
interoperability.
The wireless networks operate at speeds of 1‐11 Mbps with 2 percent
packet loss typical. The application developer must be aware of the
performance limitations and design applications that are acceptable to
the customer when run over the slower network.
Remote Wakeup over the wireless network is not possible because the
cards do not support it. An alternative is to use the system real‐time
clock wake up at a scheduled time.
Depending on the OS environment, Remote Boot may be supported,
but due to the slow network speed a large boot image may take an
unacceptably long time to load. The application developer needs to
ensure that the load is of reasonable size.