SPITFIRE MK
Item code: BH136
I. AILERON.
1.INSTALLING THE AILERON SERVOS.
1) Install the rubber grommets and brass
eyelets onto the aileron servos.
Top side
Aileron
.
2) Using a modeling knife, remove the cov-
ering at possition show below.
Bottom side
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
Instruction Manual
Servo tray.
Remove
covering
Servo tray.
Secure.
5