Adjusting The Volume - Canon Elura 60 Instruction Manual

Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The built-in speaker does not sound when you close the LCD panel.
Use headphones when using the viewfinder.
SET dial--~~~
\I\lhen.Usil"lg.Heagphones
The headphones terminal also serves as AV terminal. Headphones can only be used
when
"0"
is displayed on the screen. If not, change the setting following the
procedure below.
';;~' €ARD'~M~RA:'
'
~
+'
or.., ;.; ~vtcs"+.';
t;-.':;- X;.;..{ i
;.l~
MENU
~CR
SETUP
(CO
38)
Open the menu and select [VCR SETUP]. Select [AV/PHONES
0],
set it to
[PHONES
0]
and close the menu.
. . . 0 The built-in speaker does not sound when
"0"
is displayed.
. . 0 Do not connect headphones unless
"0"
is displayed as it produces noise.
-
CAR~
PlAY
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the volume again.
34