Canon Elura 60 Instruction Manual page 142

Message
Explanation
CANNOT TRIM You attempted to trim an image with an image size of
160 x 120, or an image not recorded in the 4:3 ratio.
READJUST TRIMMING
You ch anged the pri nt styl e after you set the tri m ming setti ngs.
PRINTER ERROR Cancel printing. Turn off the printer and turn it back on. Check
the printer status.
PRINT ERROR Cancel printing and turn off the printer. After a while, turn the
printer back on and check its status.
HARDWARE ERROR Cancel printing. Turn off the printer and turn it back on. Check
the printer status.
RECHARGE THE The printer battery is depleted.
PRINTER BATIERY
COMMUNICATION
The printer is experiencing a data transmission error. Cancel
ERROR printing, disconnect the USB cable and turn off the printer. After a
while, turn the printer back on and reconnect the USB cable.
When you are printing using the
~
¢V'
button, check the print
settings.
Or, you attempted to print from a memory card that contains a
large number of images. Reduce the number of images.
CHECK PRINT
The print setting cannot be used for printing with the
~
¢V'
SETIINGS
button.
PRINTER IN USE The printer is in use. Check the printer status.
PRINTER WARMING Printer is warming up. If the message does not disappear after a
UP few seconds, check the pri nter status.
PAPER LEVER ERROR Paper lever error occurred. Adjust the paper selection lever to the
proper position.
PRINTER COVER OPEN Close the printer cover securely.
NO PRINTHEAD No print head is installed in the printer or print head is defect.
Refer to the instruction manual of your printer.
141