Canon Elura 60 Instruction Manual page 78

Changing the Remote Sensor Mode
Two remote sensor modes and an off setting are available to prevent interference
from other Canon wireless controllers being used nearby.
~~~~
I_S_YS_T_E_M

~I
Wl. REMOTE. • • •
QlIJill1
Open the menu and select [SYSTEM]. Select [WL.
REMOTE], set it to [OFF
(((~]
and close the menu.
II
((l®J
II
appears.
I_S_Y_ST_E_M
I~I
Wl. REMOTE. • • •
(1@1
MENU
(OJ
38)
1. On the camcorder, open the menu and select
[SYSTEM]. Select [WL. REMOTE], set it to
[(((illI]
2] and
close the menu.
The selected mode appears for a few seconds.
2. On the wireless controller, press and hold the
REMOTE SET button. Press the ZOOM
T
button for
mode 2. Keep the button pressed for over 2 seconds.
If you have set the camcorder to mode 1, press the ZOOM W
button for mode 1.
o
The wireless controller returns to mode 1 when you replace the batteries.
Change the mode if necessary.
o
Make sure that camcorder and wireless controller are set to the same mode.
Display the camcorder's mode by pressing any button on the wireless controller
(except of the REMOTE SET button) and set the wireless controller's mode to
the same mode. Change the batteries if the wireless controller still does not
work.
77