Canon Elura 60 Instruction Manual page 140

L.ist of Messages
Message Explanation
m
SET THE TIME ZONE, You have not set the time zone, date and time. This message 21
DATE AND TIME appears each time you turn the power on until you set the
time zone, date and time.
CHANGE THE
Battery pack is exhausted. Replace or charge the battery
1
13
BATIERY PACK pack.
THE TAPE IS SET FOR
Cassette is protected. Replace the cassette or change the 146
ERASURE PREVENTION position of the protect switch.
REMOVE THE Camcorder stopped operating to protect the tape. Unload
I
16
CASSETIE
and reload the cassette.
CHECK THE DV INPUT DV cable is not connected, or the connected digital device is 85
turned off.
CONDENSATION HAS Condensation has been detected in the camcorder. 144
BEEN DETECTED
TAPE END
Tape reached the end. Rewind the tape or replace the
-
cassette.
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape 88
[REC MODE]
recorded in a mode other than the SP mode.
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape 88
[AUDIO MODE] recorded in 16-bit or 12-bit 4-channel sound.
CH ECK TH E CASSETIE You attempted to perform audio dubbing on a tape with a 88
[BLANK] blank section.
HEADS DIRTY, USE Video heads are dirty. Clean the video heads. 143
CLEANING CASSETIE
COPYRIGHT PROTECTED You attempted to play back a copyright protected tape.
85
PLAYBACK IS RESTRICTED
COPYRIGHT You attempted to dub a copyright protected tape. May also
85
PROTECTED DUBBING appear when an anomalous signal is received during analog
RESTRICTED
line-in recording, or during analog-digital conversion of a
copyright protected tape.
MernQryCard
.Related . Messa.ges
Message Explanation
o
NO CARD Memory card not is inserted into the camcorder. 92
~~
o a.
3
2-:
OJ
0
.-+
:::l
- ' OJ o -
:::l
-
92
I -
50 Memory Card is set for erasure prevention. Replace the
card or change the position of the protect switch.
No images are recorded on the memory card NO IMAGES
THE CARD IS SET FOR
ERASURE PREVENTION
I
CARD ERROR A memory card error occurred. The camcorder cannot record
-
or play back the image.
The error may be temporary. If the message disappears after
4 seconds and Odflashes red, turn the camcorder off, remove
the card and reinsert the card. If
[Q
changes to green, you
can continue recording/playback.
CARD FULL
No remaining capacity on the memory card. Replace with
-
another card or erase images.
NAMING ERROR
File or folder number has reached the maximum value. 95
139