Canon Elura 60 Instruction Manual page 149

148
Troubleshooting
If you have a problem with your camcorder, refer to this checklist. Consult your dealer
or a Canon Service Center if the problem persists.
Power Source
Problem Cause Solution OJ
Camcorder will not turn
Battery pack is exhausted. Replace or charge the
13
on. battery pack.
Battery pack is not correctly Attach the battery pack 13
attached.
correctly.
The camcorder switches Battery pack is exhausted. Replace or charge the 13
off by itself. battery pack.
Power save function has Turn on the camcorder.
25
been activated.
Cassette compartment
I
Battery pack is exhausted. Replace or charge the 13
will not open.
battery pack.
Cassette compartment cover Open the cassette
16
is not fully open.
compartment cover fully.
Cassette compartment Battery pack is exhausted. Replace or charge the
13
stopped during loading/
battery pack.
unloading.
The camcorder
I
Consult a Canon Service
-
malfunctions. Center.
LCD/viewfinder switches
Battery pack is exhausted.
Replace or charge the 13
on and off. battery pack.
Battery pack will not Battery packs will not Charge the battery pack in
-
charge. charge outside the temperatures between 32 OF
temperature range of 32 OF and 104 OF (DOC and 40 °C).
and 104 OF (0 "C and 4O'C).
Battery packs become hot Wait until the battery pack
~
with use and may not temperature is below 104 'F
charge.
(40°C) and retry charging.
The battery pack is Use a different battery pack.
-
damaged.
Recording/Playback
Buttons will not work. Camcorder is not turned on. Turn on the camcorder.
24
Cassette is not loaded. Load a cassette.
16
~c\51
flashes on the screen.
I
Cassette is not loaded. Load a cassette.
16
q\l flashes on the
i
Battery pack is exhausted.
I
Replace or charge the
13
screen. battery pack.
[!J
flashes on the screen. Condensation is detected. See reference page.
144
"REMOVE THE Camcorder stopped
Unload and reload the
I
16
CASSETIE" appears on operating to protect the cassette.
I
the screen. tape.
The wireless controller Camcorder and wireless Change the remote sensor
77
wi II not work. controller are not set to the modes.
same remote sensor mode.
Batteries of the wireless Replace the batteries.
20
controller are exhausted.