Starter Pinion; Installation - KYMCO GRAND DINK 50 Service Manual

8
. KICK STARTER/DRIVE PULLEY/
CLUTCH/DRIVEN PULLEY
Install the drive belt on the crankshaft.
Install the drive face, starting ratchet and
washer, then tighten the 12mm drive face
nut.
Torque: 3.5 4.0kg-m
Keep grease or oil off the drive belt and
drive pulley faces.

STARTER PINION

REMOVAL
Remove the left crankcase cover. ( Ö 8-4)
Remove the drive pulley. ( Ö 8-8)
Remove the starter pinion.
INSPECTION
Inspect the starter pinion seat for wear.
Inspect the starter pinion for smooth
operation.
Inspect the starter pinion shaft forcing parts
for wear and damage.

INSTALLATION

Apply a small amount of grease to the
starter pinion teeth.
Install the starter pinion in the reverse order
of removal.
8-11
Drive Pulley Face
Drive Face Nut
Starter Pinion
Shaft Forcing Parts
Starter Pinion
GRAND DINK 50
Starting Ratchet