Vr Adjustment; Preparation For The Vr Adjustment; Vibration」Switch - Nikon AF-S VR Zoom-Nikkor ED 70-200mm f/2.8G IF Repair Manual

VR ADJUSTMENT

When performing the VR adjustment, please refer to the [Instruction Manual] attached to the VR lens adjustment
equipment (J15380).

Preparation for the VR adjustment

①Set up the VR lens adjustment equipment (J15380) as shown in Figure below.
②Connect the personal computer to the equipment and run the personal computer.
③Mount the lens on the equipment. Set the focus ring to the infinity position and the zoom ring to TELE side.
Please refer to the next page for the procedure to mount the lens.
Laser beam outgoing port
（Laser beam）
VR lens adjustment equipment
（J15380）
Notes: The distance from the laser beam outgoing port to the radiation face should be about 5m apart.
Do not intercept the optical path of the laser beam.
This equipment uses the laser beam.
●
Do not look into the laser beam directory.
RS232C cable
- L58・AF-S VR 70-200/2.8G -
WARNING
Power switch
「SERVO」switch
「VIBRATION」switch
INC
JAA78151－R.3584.A
Personal computer