Inspection Screen Of Lens Driving Stop Accuracy - Nikon AF-S VR Zoom-Nikkor ED 70-200mm f/2.8G IF Repair Manual

(3) Inspection screen of lens driving stop accuracy
Make this inspection on both focal length70mm (W) and 200mm (T) at the following five lens positions.
①
① Click "Start insp.". The inspection of lens driving stop accuracy starts.
② If the lens stops during the inspection, input a figure [from "0" to "1000" (msec: millisecond) to delay
the process] which prevents stopping the lens, into the below "Delay time" entry field.
Note:
The delay time is the setting value set by the adjustment software. So, if the lens does not stop during
"Inspection of Lens Driving Stop Accuracy" in the end, any value can be input without problem.
However, the larger the value of "ADJUST DELAY-TIME" gets, the longer the inspection time
becomes.
Tick the checkbox when
Front lens group 90° angle
upward/downward
Added page
(Lens position when inspecting)
Tilt of Lens
Horizontal
Front lens group 90° angle upward
Front lens group 90° angle downward
- L56-11 AF-S VR 70-200/2.8G IF -
Position of index window
Up / Right / Left
Entry field
INC
JAA78151-R.3584.A
May 17 2007