Gamma And Shift Adjustment (Controlled Automatically); Electromagnetic Lock Center Position Adjustment - Nikon AF-S VR Zoom-Nikkor ED 70-200mm f/2.8G IF Repair Manual

・Gamma and Shift Adjustment (Controlled automatically)
Adjust the inclination and control center position on the basis of the position sensor output in the VR unit.
In-between times, the message to confirm the lens position of angle (0 or 90degrees) appears.
So, set the lens to the position and click the [OK] button.
When [OK] is shown on the window, move the cursor to the Next button and click it.
・Electromagnetic Lock Center Position Adjustment (Controlled automatically)
Adjust the electromagnetic lock center position.
In-between times, the message to confirm the lens position of angle (0 or 90degrees) appears.
So, set the lens to the position and click the [OK] button.
When [OK] is shown on the window, move the cursor to the Next button and click it.
・When the message that says rewriting the checksum
is finished is shown, click the [OK] button.
Then set the VR mode to OFF according to the
message and click the OK button to evacuate from
the adjustment window.
Notes：
If [NG] is shown in the middle of the adjustment,
click the Next button. This makes it possible to
evacuate from the inspection mode and to go back to
the Lens Selection window after rewriting the
checksum value. Then adjust it again.
If it becomes be [NG] even performing the adjustment
a few times, the VR unit, the gyro PCB or the main
FPC might be defective.
- L64・AF-S VR 70-200/2.8G -
INC
JAA78151－R.3584.A