System Reset - Roberts Blutune User Manual

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and release the On/Standby button to switch on the radio. Press
and release the Menu button. The menu will show on the display.
2. Press and release the Tuning Up or Down buttons until 'System'
shows on the display. Press and release the Select button.
3. Press and release the Tuning Up or Down buttons until 'Factory
Reset' shows on the display. Press and release the Select button.
4. Press and release the Tuning Up or Down buttons until 'Yes' appears
on the display. If you do not wish to carry out a system reset, highlight
'No' and then press and release the Select button. The display will
revert to the previous display.
5. With 'Yes' displayed, press and release the Select button. A full reset
will be performed. The station list and presets will be erased. The
alarm will be cancelled and settings will be set to their default values.
The display will show 'Resetting...' and after a short time the current
time and day will appear on the display.
6. See 'Operating your radio' on page 7 for further details.
In the event of a malfunction due to electrostatic discharge, mains power
supply transients or short interruptions, reset the product as above to
resume normal operation. If you are not able to perform the reset operation
as above, removal and reconnection of the power supply may be required.
If a problem persists our technical staff would be pleased to offer any
assistance on operating the radio. Our technical helpline number is
020 8758 0338.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
<System
1
<Factory Reset >
1
Factory Reset?
2-4
2-4
2-5
DAB
>
System
No <Yes>
40