Manual Tuning - Fm - Roberts Blutune User Manual

Manual tuning - FM

1. Fully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
2. Press and release the On/Standby button to switch on your radio.
3. Repeatedly, press and hold the Source button until the FM mode is
selected.
4. Press and release the Tuning Up or Down buttons to tune to a station.
The frequency will change in steps of 50kHz.
If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set the Volume to the desired setting.
7. To switch off your radio press and release the On/Standby button.
Note: If you fi nd that FM reception is poor, try repositioning the telescopic aerial.
The aerial should be fully extended and positioned vertically for optimum
reception.
If you fi nd that an FM broadcast has a lot of background hiss, this
may often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section 'Stereo / Mono setting - FM' on
page 19 for further details.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
2,7
89.30MHz
3
4
4
6
6
FM
16