Operating Your Radio - Fm Auto-Tune - Roberts Blutune User Manual

Operating your radio - FM auto-tune

1. Fully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
2. Press and release the On/Standby button to switch on your radio.
3. Repeatedly, press and hold the Source button until the FM mode is
selected.
4. Press and hold the Tuning Up button for 2 to 3 seconds to cause
your radio to search from low frequency to high frequency and to stop
automatically when it fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
6. To fi nd other stations press and hold the Tuning Up button as before.
7. Press and hold the Tuning Down button for 2 to 3 seconds to cause
your radio to search from high frequency to low frequency and to stop
automatically when it fi nds a station of suffi cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting. To switch off your radio,
press and release the On/Standby button.
15
2,9
89.30MHz
Now tuning...
3
4,6
7
9
9
Note: If you fi nd that FM reception is poor, try
repositioning the telescopic aerial.
be fully extended and positioned vertically for
optimum reception.
has a lot of background hiss, this may often be reduced
by setting the radio into Mono reception mode for the
current FM station. Please refer to the section 'Stereo
/ Mono setting - FM' on page 19 for further details.
FM
The aerial should
If you fi nd that an FM broadcast