Operating Your Radio - Fm Auto-Tune - Roberts classic blutune User Manual

Operating your radio - FM auto-tune

1. Carefully fully extend the telescopic aerial located on the rear of your
radio.
2. Press and release the On/Off button to switch on your radio.
3. Press and release the Mode button until the FM mode is selected.
4. Rotate the Tuning control clockwise and then press and release the
Auto Tune button to cause your radio to search from low frequency
to high frequency and to stop automatically when it fi nds a station of
suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
6. To fi nd other stations press and release the Auto Tune button as
before.
7. Rotate the Tuning control anti-clockwise and then press and release
the Auto Tune button to cause your radio to search from high frequency
to low frequency and to stop automatically when it fi nds a station of
suffi cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting. To switch off your radio,
press and release the On/Off button.
3
4-7
4-7
9
14