Operating Your Radio - Fm Auto-Tune - Roberts Blutune 40 Manual

Operating your radio - FM auto-tune

1. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
2. Press and release the On/Off button to switch on your radio.
3. Repeatedly, press and hold the Mode button until the FM mode is
selected.
4. Rotate the Tuning control clockwise and then press and hold the
Tuning control for 2 - 3 seconds to cause your radio to search from
low frequency to high frequency and to stop automatically when it
fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
6. To fi nd other stations press and hold the Tuning control as before.
7. Rotate the Tuning control anti-clockwise and then press and hold the
Tuning control for 2 - 3 seconds to cause your radio to search from
high frequency to low frequency and to stop automatically when it
fi nds a station of suffi cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting. To switch off your radio,
press and release the On/Off button.
13
2,9
3
4-7
9
9