Operating Your Radio - Fm Auto-Tune - Roberts SPLASH MINI Manual

Operating your radio - FM auto-tune

1. Carefully fully extend the wire aerial located on the rear of your radio
(inside the battery compartment). Place the wire antenna so that it is
as straight as possible extending either above or below the radio.
2. Press and release the On/Off button to switch on your radio.
3. Press and release the Band button until the FM mode is selected.
4. Press and hold the Tuning Up button and then release the button
to cause your radio to search from low frequency to high frequency
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
press and hold the Tuning Up button as before
or press and release the Select button.
7. Press and hold the Tuning Down button and then release the button
to cause your radio to search from high frequency to low frequency
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting. To switch off your radio,
press and release the On/Off button.
2,9
3
7 4,6
6
9 9
FM
FM
FM
FM
16