Fm Radio; Operating Your Radio In Fm Mode; Manual Tuning - Roberts Stream 94L Manual

FM Radio

Operating your radio in FM mode

1. Carefully extend the telescopic aerial and press On/Standby to switch on
the radio.
2. Press Mode as needed to select the FM Radio mode.
3. Rotate Tuning in a clockwise direction. The displayed frequency will
increase. Press Tuning to carry out an auto-tune. Your radio will scan up
the FM band from the currently displayed frequency and will stop scanning
when it finds a station of sufficient strength.
4. The display will show the frequency of the signal which has been found.
If RDS information is available, after a few seconds the display will show
the radio station name.
If you only hear hiss or interference, simply press Tuning to scan further.
Your radio may have found a spurious interference signal.
5. To find more FM stations press Tuning to repeat the scan operation. To
scan down in frequency, rotate Tuning in an anti-clockwise direction first
and then press the control. Your radio will scan down the FM band from
the currently displayed frequency and will stop scanning when it finds a
signal of sufficient strength.
6. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
7. Use the Volume control to adjust the sound level as needed.

Manual tuning

1. Rotate Tuning to tune to a station. The frequency will change in steps of
50kHz.
2. Adjust the volume.
35
60
DAB
FM 10:30
103.40MHz
5
RDS
FM
10:30
Heart FM
The best new
music and
entertainment
5
RDS